The Makefile in (TOPDIR)archMYARCHboot has to have CROSSCOMPILE (mipsel-linux, MIPS little-endian cross-compiler tool-set in this case) and LOADADDR (address at which the kernel image would be loaded) defined as per the configuration.If a new processor was designed and developed by a semiconductor company, they had to depend on an operating system company to port their operating system to the new processor.The other issue was with the development tools (compiler, debugger, simulator, and so on) for the given processor.Usually the operating system company also provided these tools.
Php Serial Port Communication Linux Kernel Drivers That HadIn addition, the peripherals around the processor required drivers that had to be developed for the specific operating system. Php Serial Port Communication Linux Kernel Code For TheWith the introduction of Linux into the embedded sphere, it has become possible for the semiconductor company itself to port an operating system to a new processor, since the source code for the Linux kernel is available as open source. The GNU 1 project provides a wealth of development tools that support Linux and are also open source. In addition, many device drivers are available for Linux, which could be used directly or as a starting point for your target devices. In addition, the development board also supported EDO DRAM, flash ROM, I 2 C RTC, I 2 C EEPROM, and I 2 C serial bus. An architectural block diagram of the ASIC is shown in Figure 2. A ramdisk (explained later in the article) served as the root file system. A ramdisk was used initially in order to speed up the porting process. In addition, the article deals only with minimum kernel functionality. The current development was done on a PC running Red Hat Linux. The Linux VR Web site (see References) is a good starting point for cross-development tools and sources for Linux on MIPS. The following cross-development tools need to be downloaded and installed on the PC running Linux: cross-binutils-as, ld, and so on; C cross compiler; and cross-development C libraries. The detailed steps for installation are available along with the tools. One of the most important steps in porting Linux to a new target platform is to have a very clear understanding of how the kernel sources are organized. The following directory structure is not complete and includes only parts that are of interest to this article. Each supported architecture subdirectory has four major subdirectories. Each type of device has further subdirectories, such as char, block, net, and so on. This has further sub-directories for each supported file system (ext2, proc, and so on). It has further subdirectories for common include files (for all architectures), one for every architecture supported, and a couple of other subdirectories.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |